User Manual

Operation 5-27
5.18.2 Edit Screen
To run a program from the Edit Screen:
1. Load the program you want to run as described in 5.17 Loading a Program.
2. Load a new product (board or carrier) into the work area.
 When a program is run from the Edit Mode, the system does not check to see if the
board is in the appropriate position. Running from the Edit Mode is generally used for
program testing. Extreme care should be exercised.
3. Start the run in one of the following ways:
 Press the
[F9] key.
 From the menu bar, click on
Run > Run.
 Click the
Run button on the toolbar.
 NOTES When running your program from the Edit Screen, you have the option to click the
Step
button instead of the Run button to step through the loaded program.
Each click on the button performs one instruction. You may also click on Pause
or Stop
anytime during program execution.
The procedures above run the entire program. Press the
[F6] key or select Run > Run
Pattern/Procedure
from the menu bar to run an individual pattern or procedure.
Figure 5-20 Running a Program - Edit Screen