User Manual

Parts Replacement 9-1
9 Parts Replacement
9.1 Overview
This section includes general information for ordering recommended spares and replacement parts for
your Select Coat SL-940E/SL-941E Series Conformal Coating System. Part numbers can be found in
Appendix C. This section also contains the following procedures:
• Parts Ordering Information
• Unpacking and Inspecting Replacement Parts
• Gaining Access to Coating System Components
• Replacing Conveyor Chains
• Replacing the Camera Lens
• Replacing Fuses
NOTE This section does not include the removal and replacement of coating applicator
components. Refer to the manual for your specific coating applicator for recommended
maintenance procedures.
9.2 Safety First
Operation of the SL-940E/SL-941E involves heat, air pressure, electrical power, mechanical devices, and
the use of hazardous materials. It is essential that every person servicing or operating the coating system
fully understands all hazards, risks, and safety precautions. Refer to Section 2 - Safety for additional
information.
WARNING! CAUTION!
To ensure optimal performance and safety, it is necessary to install the coating
system and its components in a facility that meets the necessary requirements
listed in Section 10 - Specifications. If you have any questions, please contact
Nordson ASYMTEK Technical Support.
9.3 Record Keeping
The type of service performed should be recorded in the coating system maintenance records. Dates, part
numbers/serial numbers of replaced parts, names of technicians, and other pertinent data should be
recorded.
WARNING! Some part replacement procedures involve the use and disposal of hazardous
materials. Always follow the material manufacturer MSDS, facility requirements,
and local regulations for protection of personnel and disposal of materials.