User Manual

3-2 Installation

To uncrate and place the coating system:

1. Check the “Tip & Tell” and "Shockwatch" devices, both on the outside of the shipping crate

and on the coating system, to make sure that the coating system has not been dropped or

tipped. If any of these devices has been activated, contact Nordson ASYMTEK.

2. Locate and remove the envelope on the outside of the shipping crate. Open the envelope

and locate the shipping list.

 As you unpack each item inside of the box, identify the item, locate it on the shipping

list, and place a checkmark next to the item.

3. Referring to the uncrating instruction sheet, use the flat bar and hammer to remove the lid

and sides of the crate.

WARNING! CAUTION!

Personnel should wear gloves and safety glasses while removing the top and sides

of the crate. Sufficient personnel should be used to lift and control the crate to

prevent serious injury to personnel or damage to the coating system.

4. Remove the four machine-to-crate shipping brackets attached to the pallet using a 1/2-inch

wrench and 9/16-inch wrench (not provided).

5. Remove the two 1/2-inch hex head screws clamping the four shipping brackets to the

levelers.

Item Description Item Description

1 Foot Restraint Bracket 5 Lag Bolts and Washers

2 Hex Head Screws and Washers 6 Hex Nuts and Washers

3 Leveler (foot) 7 Post Nut

4 Machine-to-Crate Shipping Bracket 8 Lock Nut

Figure 3-1 Removing the Shipping Brackets