User Manual

Installation 3-7
4. Place the box level between the front and rear conveyor rails along the Y-axis (Figure 3-7).
5. Observe the position of the bubble within the level’s window.
 The bubble should be centered, indicating coating system is level from front-to-back.
Figure 3-7 Leveling the Coating System – Y-Axis
6. If necessary, adjust the levelers (Figure 3-6) of the coating system as follows:
a. If necessary, loosen the 1 1/2-inch lock nut on the leveler.
b. Turn the 1 1/2-inch post nut in the desired direction until the level’s bubble is centered,
indicating that the system is level from front-to-back.
 Turning the post nut clockwise raises the coating system. Turning the post nut
counterclockwise lowers the coating system.
7. Check the system for stability by pressing up and down on one of the top corners of the
coating system. If one leveler is lower or higher than the others, the coating system will
rock back and forth. Adjust the levelers so that they are all bearing the weight equally.
8. Re-level the coating system from side-to-side and from front-to-back, if necessary.