User Manual

Power-up and Testing 4-17
4.14 Conveyor Function
To check function of the Conveyor:
1. Load a sample workpiece (included in the accessories crate) onto the conveyor port.
 If necessary, adjust the distance between the conveyor rails to fit the sample workpiece.
Refer to 5.7 Conveyor Operations.
2. Select
Edit > Edit Mode from the ECXP Operator Screen to access the ECXP Edit Screen.
3. Select
Utilities > Conveyor Utilities > IO Tool from the menu bar (Figure 4-13).
Figure 4-13 ECXP Edit Screen - Conveyor Utilities
4. Locate the I/O labeled Left Sense (Figure 4-7).
5. Manually move the workpiece under the Board Sensor.
6. Watch the Left Sense bit in the I/O Test dialog box and make sure that it toggles
ON and
OFF as the workpiece passes under the sensor.
 If the bit does not toggle ON and OFF, the sensor location may need to be adjusted.
Refer to Section 8 - Troubleshooting.
7. Repeat Steps 5 through 6 for each Board Sensor on your coating system.
8. Click on
Utilities > Conveyor Utilities > Load Board.