User Manual

Operation 5-9

5.10.2 Reservoir Pressure Regulator and Gauge

The Reservoir Pressure Regulator controls the pressure of the fluid reservoir for the SC-205 Non-

Circulating Film Coater, the SC-300 Swirl Coat Applicator, and the SC-400 Conformal Coating Jet. For

more details on how the air is used for coating applicator operation and recommended pressure setting,

refer to the manual for your specific coating applicator.

To adjust the reservoir pressure:

1. Locate the Reservoir Pressure Regulator adjustment knob inside the front cabinet.

2. Unlock the knob by pulling it outward.

3. Rotate the Reservoir Pressure Regulator adjustment knob counterclockwise until the

Reservoir Pressure Gauge registers zero (0).

4. Rotate the knob clockwise until the Reservoir Pressure Gauge registers 413 kPa (60 psi).

TIP For accurate pressure adjustment, lower the pressure below the desired level and then

increase to the desired pressure.

 If there is an air leak, identify the source, shut off the facility air, and fix the leak

before proceeding.

5. Lock the knob by pushing it inward.

Item Description

1 Reservoir Pressure Gauge

2 Reservoir Pressure Regulator

Figure 5-5 Adjusting the Reservoir Pressure