Instructions / Assembly

12
Step Installation Procedure(ex. @Garage)
Necessary Tool
6
Push the "⑫Flex Feeder" into the tip of the "③Flex Pipe 2"".
󰒆Flex Pipe 2"
󰒏Flex Feeder
7
Insert the " ③Flex Pipe 2" " into the "⑥Base Junction Support" until you touch the inside
of the rain cap on the roof.
With the " ③Flex Pipe 2" " fully inserted into the vent, make a mark at the "⑥Base
Junction Support" so you can check for movement during the rest of installation.
Marker
Step-1
(Work where equipment is installed)
Install the " ⑫ Flex Feeder" always, even in the case of straight B-Vent runs.
("
⑫ Flex Feeder" prevents debris from falling into the "③Flex Pipe 2"".)
Be sure to do
When pushing "③Flex Pipe 2"" through the B-Vent, if there is unusual feeling
(touching the bump of screw, etc.), do not continue to push in and stop the installation.
Be sure to do
Do not use the "③Flex Pipe 2"" at any jobsite with vent runs longer than 35', do
not join two shorter flex pipes together even if the run is less than 35'.
Prohibited
Point
Before inserting, try to straighten curl of the tip of
" ③Flex Pipe 2" " as much as possible.
However, when doing so, bending radius should be more than 7 inch.
Point
Continue to push
" ③Flex Pipe 2" " strongly until the end and make sure that it does not
stop in the middle.
r>7 inch