Installation Guide
13
Step
Installation Procedure(ex. @Garage)
Necessary Tool
8
Take extra care to ensure that the "③Flex Pipe 2"" does not slip by checking the mark
you made on the "③Flex Pipe 2"". Firmly tighten "③Flex Pipe 2"" with "⑥C. Flex
Pipe Clamp", but be careful not to over tighten as it may distort the "③Flex Pipe 2"".
Check to see if it is firmly secured by pulling it by hand.
The tightening torque should be between 7 and 10 in lb..
The assembly image figure for all parts in below Step 2Procedure 9 14)
Use this Image to check for correct assembly of the components.
9
Grab Bag Labeled "Step-2" and necessary tools for this step of the installation.
Climb up on the roof and access the Rain Cap.
Ladder
Wet Towel
Marker
Bag"Step-2"
Step-1
(Work where equipment is installed)
Step-2
(Work on rooftop)
Point
When climbing up on the roof, use appropriate fall protection to guard against falls. Make
sure that safety comes first at your own risk.
Final drawing in this Step2
(a cross section)
Final image in Step 2
䐡Flex Pipe 2”
䐠 Top Flex Support
䐟
Universal Rain Cap
Flat head
Screwdriver
Box wrench
(5/16")
or
PVC Cutter
Box Cutter
or
Step-2