Installation Guide

17
Step Installation Procedure(ex. @Garage)
Necessary Tool
16
Insert "⑧Rigid 45 Elbow Set" to the equipment's vent connector pipe. When inserting "⑧Rigid
45 Elbow Set", there is tension when it passes through the o-ring within the equipment’s vent
connector pipe. Continue to insert "⑧Rigid 45 Elbow Set" until it is firmly seated all the way into
the base of the vent connector pipe.
󰴫Rigid 45 Elbow Set
17
Follow the nextPointand cut the " ③Flex Pipe 2" " into appropriate length.
Marker
Point
If it interferes with water and hot water piping, adjust "⑧Rigid 45 Elbow Set"'s angle so
that it does not interfere. If the contact is unavoidable, take measures such as inserting
heat insulator so that it does not have direct contact.
Step-3
(Work where equipment is installed)
At this step, be very careful when cutting the "③Flex pipe 2"". If it is cut too
short, you must dispose of the vent or use it on another installation where
a shorter length is required. These vent pieces cannot be lengthened.
Be sure to do
Do not disassemble
"
⑧Rigid 45 Elbow Set" to use.
Be sure to do
PVC Cutter
Box Cutter
or
《 EZTR40 》 3"
《 EZTR50/75 》 4
3
/
4
"