Use and Care Manual

51
Installation
1. Apply the Mounting Packing to the rear side of
the Remote Controller.
2. Connect the Remote Controller wires to the
cord supplied with the Water Heater.
3. Remove the cover of the Remote Controller,
mark the location of the screw holes, and drill
holes for the Dry Wall Anchors.
4. Insert the Dry Wall Anchors, screw the Remote
Controller to the wall and reattach the cover.
Remote controller wires
Rear Side of
the Remote Controller
Remote
Controller Cord
Mounting Packing
(take off the paper)
Dry Wall Anchor
Anchoring Screw
Post-installation Checks
1. Check if the Remote Controller is installed
securely.
2. Check the Remote Controller operation. (See
Owner's Guide)
• Press the button approximately 5 seconds
after connecting the electrical power to the
Water Heater.
• Check that the display appears on the Remote
Controller.
Adjusting the Temperature / Water Quantity
Display
3. Press the button and hold it in for 2 seconds
or more.
4. Press the button several times until the item
number “12” is displayed.
  /
buttons.
• °F/gal (Fahrenheit/Gallon): default setting
• °C/L (Celsius/Liter)
6. To confirm the setting, turn the Water Heater
on by pressing the button on the Remote
Controller.
1. Turn the Water Heater off by pressing the
button on the Remote Controller.
2. Disconnect, then reconnect the electrical power
to the Water Heater.
NOTE
The setting must be done within the
first 10 minutes of connecting the
electrical power to the Water Heater.
Installation of the Remote Controller