Use and Care Manual

ManualsBrandsNoritz ManualsAccessoriesNoritz Flex Vent 2" Diffuser Kit for EZ2FVK-2

54

2. Remove the cover from the Remote Controller.

(The cover is set in the Remote Controller.)

4. Check the terminal is covered with Section A

( ) of the insulating cover (clear, see the figure

above).

NOTE

If the Y-shaped terminal is not

covered, the exposed section may

come into contact with the Mounting

Bracket resulting in improper

operation or failure.

3. Connect the Remote Controller wires to the

cord supplied with the Water Heater.

Do not remove the

remote controller wires

from the terminal block,

connect these wires to

the Remote Controller

Cord.

For routing the remote

controller wires,

carefully cut the wire

routing tab of the

thinned portion of the

cover before mounting

it to the wall.

THIS SIDE UP

Section A

Insulating cover (clear)

Do not remove.

Remote Controller

Cord

Remote controller

wires

Wires routing tab

Cover

5. Secure the remote controller wires by winding

them around the notches.

Pass the remote

controller wires

through the

notch.

Winding around

the notches

[For exposed wiring]

[For wiring inside

the wall]

Mounting Br

acket

Remote

controller

wires

6. Attach the Remote Controller to the Mounting

Bracket.

Main

remote

contro

ller

Mounting Bracket

①Insert the bottom of the

Main remote controller

into the groove at the

bottom of the Mounting

Bracket.

Groove

• Do not install on the

Mounting Bracket by force,

the hooks may break.

• Check for proper alignment

in the groove or for loose

wires obstructing the

Remote Controller.

②Push in the 2 hooks on top of the

Main remote controller completely.

Hooks

7. Secure the Main remote controller using the

Round Head Machine Screws.

Round Head

Machine Screw

(included part)

8.

Reattach the cover previously removed on step 2.

Push the 4 corners of the cover

until there is a click.

Click Click

ClickClick

NOTE

Incomplete installation may result

in failures such as switch operation

failure.

To remove the cover,

press the clear tabs

on the bottom of the

Remote Controller while

pulling the cover forward.

Cover

Main remote

controller

Installation of the Remote Controller