NCC300 Owner's Guide

20
1. Check that the current time is properly set.
(Setting the time p.17)
2. Check the button is set to "OFF"
Cover shown
in the open
position.
This example describes setting the "ON time" and "OFF time" to 10:00 am and 8:00 pm, respectively.
1
* You can set the time regardless if
the
button is "ON" or "OFF".
* The previously set "Start time"
and "End time" are displayed.
2
3
1) Set the ON time to
"AM10:00" using
the buttons.
2) Press the
button
to complete the setting.
1)
2)
1)
2)
1)
2)
Set the time to turn "ON" or "OFF" the button automatically
Operation Screen Display Description
For All Systems
Automatic Water Heater “ON” or “OFF” Operation
* If you set the time to turn "ON" or "OFF" the
button, the button is automatically
turned "ON" or "OFF" at the set time every
day by just turning the button "ON".
* It is also possible to set only “ON” or
“OFF” operation.
* For recirculation systems, circulation is
started or stopped according to the
button condition, "ON" or "OFF".
* The time changes in 10-minute
increments with each press of the
button, and then in 1-hour increments if
the button is kept pressed down.
* If the previous setting is OK, press the
button without setting "Start time".
* If you do not want to set the "Start time",
select "- : --" (located between AM 11:50
and PM 0:00 settings).
* The time changes in 10-minute
increments with each press of the
button, and then in 1-hour increments if
the button is kept pressed down.
* If the previous setting is OK, press the
button without setting "End time".
* If you do not want to set the "End time",
select "- : --" (located between AM 11:50
and PM 0:00 settings).
1) Press the button
inside the cover,
Select "Set PROG"
using the
buttons.
2) Press the
button.
Preparation
1) Set the OFF time to
"PM8:00" using
the
buttons.
2) Press the
button
to complete the setting.