NCC300 Owner's Guide

39
The water is cold when only a
singlextureisopen.
Theunitwillnotheatthewateriftheowrateislessthan
0.5 gallons (2L) per minute.
Openthexturemoreoropenotherxturessothatagreater
owpassesthroughtheunit,andtheunitshouldbegin
heating again.
Amount of Hot Water
The amount of hot water at a
certainxtureisnotconstant.
• Whenhotwaterisdemandedatotherxtures,theamount
availablemaybereduced.Themaximumowavailable
from this unit is 12.5 GPM (47.4L/min.) at a 45°F (25°C)
temperature rise.
• Pressureuctuationsandotherplumbingconditionscan
causethetemperatureandpressureataxturetobe
unstable, but it should stabilize after a short time.
There are some types of hot water taps that discharges
largevolumesofhotwateratrstbutstabilizeaftertime.
To keep the temperature stable, the heater limits the
amountofwaterthatcanowthroughittoasmallamount
initially, but the amount increases over time.
The amount of hot water in the tub
is less/more than the set amount.
• Whenhotwaterisusedforotherxtureswhilellingthe
bathtub,thetubwillnotllasmuch.
• Ifthereiswaterinthetubalready,orwhenllingisstopped
andrestarted,thetubwillllmore.
Theowmeteralarmdoesnot
soundevenwhenlledtotheset
amount.
• Theowmeteralarmissettosoundwhenhotwater
is continuously discharged for the set volume of water.
If mixing valves are used, or if cold water is mixed with hot
wateratthexture,thetubwillllmorethanthesetting
oftheowmeteralarm.
Amount of hot water available
has decreased over time.
Fluctuations in hot water
temperatures.
Set water temperature at 115°F to 120°F or 48°C (118°F) to
50°C (122°F).Thiswillallowyoutouseahigherowofhot
waterthusmeetingtheminimumowrequirementof0.5
GPM (2L/min.).
• Cleanthewaterlterofanydebris ( p.36)
(Continued)
Setting temperature cannot rise.
Is the maximum temperature setting appropriate? ( p.23)
•Isthewaterlterclogged?( p.36)
• If the supply water is hard and has not been treated, scale
can build-up in the water heater and decrease the
maximum amount of hot water available. Scale can be
removedfromthewaterheaterbyushingtheunit
periodically. To prevent scale from forming in the water
heater, a water softener or scale inhibitor is
recommended.