Datasheet

Virus & Spyware Protection z 27

Simply select the combination of parameters that you wish to use and

specify them on the command line.

3. For a list of available parameters, enter nvcc /?

Exclude list

You may want to speed up the scanning process by excluding certain

files from scanning. Note that excluding files or areas from scanning is

a decision at the expense of security.

Files on the Exclude list are not scanned. Reasons for not scanning

certain files may be that they trigger false alarms, or they are too time-

consuming to scan. At any rate, we recommend that you scan files on

the exclude list regularly by running scheduled or on-demand scans

(page 21).

You can create exclude lists for the On-access and the On-demand

scanners.

Create an exclude list

1. Go to Virus & Spyware Protection | Configure | Scanners.

2. Select the relevant tab (On-access scanner or On-demand scanner).

3. Adding separate files: in the Add to list box, type in the path and

file name and click Add, and then Apply.

4. Adding disk drives or folders: select drive letter and click Add

selected, or click the drive letter and browse for the folder(s) you

wish to exclude from scanning. Click Add selected and then

Apply.

5. The newly added drives, folders or files appear in the list in the

upper part of the dialog.

6. To remove entries from the list, select the relevant entry and click

Remove selected. Click Apply when you’re done.

Note: NSS does not check if the files, folders or drives you add to the

exclude list really exist. Be careful to enter the correct names

and paths.