Installation Guide

ManualsBrandsNorpole ManualsAppliancesCommercial 45 cu. ft. 2-Sliding Glass Door Refrigerator in Black

GLASS DOOR MERCHANDISERS

COMMERCIAL REFRIGERATOR AND FREEZER

USER’S MANUAL

GLASS DOOR MERCHANDISERS

PLEASE READ THE MANUAL THOROUGHLY PRIOR TO

EQUIPMENT SET-UP, OPERATION AND MAINTENANCE.

Model: NPGR1-S9B, NPGR1-S, NPGR1-SB, NPGR2-S, NPGR2-SB,

NPGR3-S, NPGR3-SB, NPGR2, NPGR2-B

Summary of content (4 pages)

PAGE 1
GLASS DOOR MERCHANDISERS COMMERCIAL REFRIGERATOR AND FREEZER USER’S MANUAL GLASS DOOR MERCHANDISERS Model: NPGR1-S9B, NPGR1-S, NPGR1-SB, NPGR2-S, NPGR2-SB, NPGR3-S, NPGR3-SB, NPGR2, NPGR2-B PLEASE READ THE MANUAL THOROUGHLY PRIOR TO EQUIPMENT SET-UP, OPERATION AND MAINTENANCE.
PAGE 2
GLASS DOOR MERCHANDISERS INSTALLATION ■ The refrigeration system operates most efficiently when installed in an area with cool, dry air circulation. ■ There must be at least 6 inches of clearance on both sides and the back of the cabinet. ■ Select a location away form the heat and moisture generating equipment such as stoves, ovens, etc. ■ Avoid direct sun rays. ■ Be sure that the floor where you intend to install the unit is strong and level enough to support the total weight of the unit and its contents.
PAGE 3
GLASS DOOR MERCHANDISERS ﹡Wipe inside with dry cloth, and you may leave the door slightly open to eliminate moisture and odor. OPERATION/MAINTENANCE ■ When loading the unit: ﹡Be careful not to block the air duct located at the back and the fan on the ceiling of the unit with contents. ﹡Blocking the air flow may cause decrease in performance. ﹡For the best performance, maintain at least 4 inches of clearance between the contents and the air duct.
PAGE 4
GLASS DOOR MERCHANDISERS ▲ Check to see if contents are blocking the air duct. ▲ Check the temperature controller for possible incorrect temperature setting. ▲ Check to see if refrigerant charge is low. ▲ Make sure the door is completely closed. NOT INTERIOR LIGHT ▲ Turn off the light switch and turn it on again. ▲ Make sure the bulb is correctly inserted into the sockets. ▲ Check the bulb, and replace it if blown. UNIT NOISY ▲ Make sure to install the unit on level surface.