User Manual

9
Figure 4
Figure 3
Figure 5
Figure 6
LOCATION
Your installation location should meet the following requirements:
• Make sure that you install your unit on a level surface to
minimize noise and vibration.
• The unit must be installed near a grounded plug, and the
Collection Tray Drain (found on the back of the unit) must be
accessible.
• The unit should be located at least 12” (30cm) from the
nearest wall to ensure proper air conditioning.
• DO NOT cover the Intakes, Outlets or Remote Signal
Receptor of the unit, as this could cause damage to the unit.
WINDOW INSTALLATION KIT
1. Preparing the Exhaust Hose Assembly:
Press the exhaust hose into the window
slider adaptor and unit adaptor and clamp
with the buckles of the adaptor.
2. Attach the Exhaust Hose Assembly to the Unit:
Push the Exhaust hose into the air outlet
opening of the unit along the arrow direction.
3. Prepare the Adjustable Window Slider:
Measure the size of your window opening.
If needed, cut the window slider to the
correct length. You may need both window
sliders, in which case, slide Window Slider
B into Window Slider A, adjust to correct
size, and use the bolt to fasten the window
sliders together.
INSTALLTION
NOTE: Once the Exhaust Hose Assembly and Adjustable Window Slider are prepared, install according
to the type of window you are using.
Type 1: Hung Window Installation
1
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Cut the adhesive foam seal
A and B strips to the proper
lengths, and attach them to
the window sash and frame
as shown.
Exhaust Hose Exhaust Hose Assembly
Unit Adaptor
Bolt
Window
Slider B
Window
Slider A
Window Slider Adaptor