User's Manual

Page 22
Norsat ODU 090-25012-00 Norsat
a 25W SSPA mounted on the back of the reflector if the 40W
ODU was an upgrade for an existing system;
19. Thread the second fastening collar to the elevation jack
screw, and tighten both collars to block to lock in place.
Parabolic Reflector
The reflector is divided into four segments that each comprise a
quarter of the dish. One reflector segment is permanently
fastened to the support base, leaving three reflector segments to
be assembled.
20. Remove the three unsecured segments from the antenna
segment storage bag.
21. Locate the segment with the A label, and align it with the A
label on the permanently secured segment; refer to Figure 14
22. Insert the pins into the guide holes and fasten the cam locks
by turning them clockwise, to secure the segment; refer to
Figure 14 and Figure 15.
FIGURE 14
Guide Holes and Cam Locks
23. Align the B label on each of the remaining segments; refer to
Figure 15.
24. Secure the two segments together by inserting the pins into
the guide holes, then fasten the cam locks by turning them
clockwise.
25. Align this piece with the segments already fastened to the
support base; refer to Figure 15.
26. Secure the piece by inserting the pins into the guide holes
and fastening the cam locks by turning them clockwise.