Specifications

f) Production test procedures for
ensuring compliance.
The module grantee shall provide a
notice that any deviation(s) from the defined
parameters of the antenna trace, as described
by the instructions, require that the host
product manufacturer must notify the module
grantee that they wish to change the antenna
trace design. In this case, a Class II permissive
change application is required to be filed by
the grantee, or the host manufacturer can
take responsibility through the change in FCC
ID (new application) procedure followed by a
Class II permissive change application.
2.6 RF exposure considerations
It is essential for module grantees to clearly
and explicitly state the RF exposure conditions
that permit a host product manufacturer to
use the module. Two types of instructions are
required for RF exposure information: (1) to
the host product manufacturer, to define the
application conditions (mobile, portable – xx
cm from a person’s body); and (2) additional
text needed for the host product
manufacturer to provide to end users in their
end-product manuals. If RF exposure
statements and use conditions are not
provided, then the host product manufacturer
is required to take responsibility of the
module through a change in FCC ID (new
application).
YES
Refer to instruction
The modular can be installed or integrated
in mobile or fix devices only. This modular
cannot be installed in any portable device.
This modular complies with FCC RF
radiation exposure limits set forth for an
uncontrolled environment. This transmitter
must not be co-located oroperating in
conjunction with any other antenna or
transmitter. This modular must be installed
and operated with a minimum distance of
20 cm betweenthe radiator and user body.
2.7 Antennas
A list of antennas included in the application
for certification must be provided in the
instructions. For modular transmitters
approved as limited modules, all applicable
professional installer instructions must be
included as part of the information to the host
product manufacturer. The antenna list shall
also identify the antenna types (monopole,
PIFA, dipole, etc. (note that for example an
“omni-directional antenna” is not considered to
be a specific “antenna type”)).
For situations where the host product
manufacturer is responsible for an external
connector, for example with an RF pin and
antenna trace design, the integration
YES
Refer to instruction
The module is limited to the following
antenna:
Antenna Type: PCB Antenna Antenna
Gain: 0dBi