FAQ

How do I attach NorskTrack™ or NorskWall™ to the wall?

The panels are attached using screws provided or common drywall screws through the panel and directly into

the interior studs of the wall. Our patented Kwik-Connect™ panels were designed to eliminate unsightly screw

heads normally found in other products.

1. Mark the desired height of the NorskWall™ on your wall.

2. Draw a level line at this point (start at stud) to the end of where you want the Wall to stop.

3. Mark with pencil your stud locations on this level line.

4. Place Top Rail just above line (so you can see stud marks) make sure it is level and install

screws starting them into indented slots at each stud location.

5. If creating a wall, continue adding more top rails across desired line until top rail of Wall is

complete. Make sure you use a dowel and retaining ring in middle of each dowel to connect

each top rail together. (If possible, try to use 1/2 of one stud for each piece of top rail).

Lightly tap end of top rail with mallet to seat top rail onto the dowel.

6. Now that your top rail is complete and level, use a level and draw a line straight down each

stud mark to just below bottom of last panel that you will use for NorskWall™. Now take each

Norsk™ panel and slide into top rail, which will cover screws from previous steps.

7. Install screws in bottom track again where indent is located and where you have marked the studs.

8. If you are only creating a single column NorskWall™ skip to Step 9.

9. If you are creating a NorskWall™ with multiple columns, add dowels in each hole with retaining rings

in middle of each prior to connecting next panel and repeat Step 6 until all panels are installed.

10. Install Bottom Rail pieces by simply placing them in bottom track (where screws are installed) and

firmly pushing and locking them in.

11. LAST Step: Use long piece of side trim and cut to size (hack saw or other appropriate saw

for cutting PVC) and install side trim clips (1 clip per slat) by sliding clip(s) onto rail located in side

trim and snap into side of panels.

Please see instructions included with each pack of NorskWall/Track. Instructions are also available for download

on our website www.norsk-stor.com

The world's trusted brand for alternative

flooring, organization & lifestyle products.

FAQ

’

NORSKWALL

™

PAGE 1
The world's trusted brand for alternative flooring, organization & lifestyle products. FAQ’S NORSKWALL™ How do I attach NorskTrack™ or NorskWall™ to the wall? The panels are attached using screws provided or common drywall screws through the panel and directly into the interior studs of the wall. Our patented Kwik-Connect™ panels were designed to eliminate unsightly screw heads normally found in other products. 1. Mark the desired height of the NorskWall™ on your wall. 2.
PAGE 2
NORSKWALL™ FAQ’S Can NorskTrack™ or NorskWall™ be installed over drywall? Yes. NorskTrack™ or NorskWall™ can also be installed over existing plaster, drywall, and concrete walls. To install over concrete walls use firing strips or a concrete drill bit and “tap con” flathead screws to attach the same way as you would into a stud wall (pre-drilling screw locations). Does NorskTrack™ or NorskWall™ eliminate the need for drywall on the wall between the home and the garage? No.
PAGE 3
NORSKWALL™ FAQ’S Is NorskTrack™ and NorskWall™ waterproof and mold resistant? Yes, NorskTrack™ and NorskWall™ is waterproof and mold / mildew resistant. Can I add additional organizing or Norsk™ panels when needed? Yes. Norsk™ modular systems make it easy to add more panels to your existing system as your storage needs arise. On each completed end, it is easy to configure connections that allow you to add additional panels as your needs change in the future.