User's Manual

42
The installer can set different options for the system to customize the installation. The options listed
below show the regular settings and have an area or check box to note custom settings.
Siren Run Time
If there is a burglary, panic (police), or emergency alarm, the Control Panel will sound the siren for a
preset time. After the time expires, the siren will stop sounding. (Auxiliary alarms run for an unlimited
time.)
SIREN RUN TIME
❑ 4 Minutes
(regular setting)
❑ 8 Minutes ❑ 12 Minutes ❑ 16 Minutes ❑ Unlimited
Fire Horn Run Time
If there is a fi re or carbon monoxide alarm, the Control Panel will sound the fi re alarm horn for a
preset time. After the time expires, the fi re alarm horn will stop sounding.
FIRE HORN RUN TIME
❑ 4 Minutes
(regular setting)
❑ 8 Minutes ❑ 12 Minutes ❑ 16 Minutes ❑ Unlimited
Exit Delay
The Exit Delay begins immediately after arming the system. The delay gives you time to leave through
the designated exit/entry door without setting off the alarm. During the Exit Delay beeps sound, and
faster beeps sound during the last 10 seconds. (NOTE: Arming remotely does not start an Exit Delay).
EXIT DELAY
❑ 60 Seconds (regular setting)
_________ Seconds For _______________ Door
Entry Delays
The Entry Delay begins when the designated entry/exit door is opened while the system is armed.
The delay gives you time to disarm the system before triggering the alarm. You must enter a User
Code on the Control Panel or Wireless Keypad before the Entry Delay time expires. During
the Entry Delay, beeps sound to remind you to disarm the system.
The system supports two different Entry Delays. Entry Delay #1 is for your primary entrance door;
Entry Delay #2 is for a secondary entrance (such as a garage door) and is usually set longer to give
you time to get to the keypad and disarm the system.
ENTRY DELAY #1
❑ 30 Seconds (regular setting)
_________ Seconds For _______________ Door
ENTRY DELAY #2
❑ 45 Seconds (regular setting)
_________ Seconds For _______________ Door
Installer Set Options