User's Manual

If a Burglary Alarm Occurs

If an armed sensor is tripped while the system is armed in the Stay or Away Mode, an alarm will

occur and the siren will sound. Delayed sensors will start the Entry Delay to allow time to disarm

the system. Instant sensors trigger the alarm right away. Most sensors will trigger the alarm siren,

some sensors may be set to trigger a silent alarm without sounding the siren.

Burglary Alarm Siren

If there is a burglary alarm tripped while the system is armed, the Control Panel will sound the alarm

siren for a preset time (the time can be changed; see the Installer Set Options section of this manual).

After the time expires, the siren will stop sounding. The system can also be set by the installer to

allow one or two alarm cycles per sensor, per arming period. (Siren sounds are steady for burglary,

intermittent horn for ﬁ re, and pulsed for CO detection.)

Alarm Memory

If an alarm has occurred while the system was armed, the Disarm Screen will show the time and date

of the alarm and the sensor(s) that triggered the alarm.

After the system is disarmed, the Alarm Memory screen will be displayed. The Alarm Memory Screen

shows the sensor(s) that have caused the alarm. If more than one sensor has been triggered, the

display will show the order that alarms occurred. The alarm memory will automatically clear

the next time the system is armed. You can also check the CLEAR ALARM HISTORY button and

press OK to manually clear the alarm memory (24-hour ﬁ re and CO sensors that are still violated will

remain in alarm memory).

Anytime there are events stored in alarm

memory, the Security Screen will display the

button. The number on the button is the

number of sensors that triggered during the

alarm (remains until acknowledged). Press the

button to view the Alarm Memory Screen.

Optional 2-Way Voice Communications

2-way voice communications provides a method for alarm veriﬁ cation and can provide emergency

assistance. The Control Panel contains a built-in microphone that can monitor sounds around the area

of the Control Panel. The built-in microphone and speaker allows 2-way voice communications with

a Central Station operator after an alarm. The operator can converse with people in the premises

through the Control Panel’s speaker and microphone.

Your installer can set the system to use 2-way voice communications after an alarm and/or after a

panic alarm is triggered.

✓ NOTE: If a panic alarm or sensor is set for a silent alarm, the operator will only be able

to listen and not be able to talk. This is for your protection.

Burglary Protection

Disarm Screen Showing Alarms

Alarm Memory Screen

Security Screen with Alarm Memory Button

Alarm

Memory

Button