User's Manual

Key Fob Arm/Disarm Sound

The system can be set so when it’s armed or disarmed by a wireless key fob, a beep will sound

through the internal and external sounders to indicate that the key fob’s signal was received. This

helps in installations where the Control Panel is not visible or there are no other system status

indications at the key fob’s location.

KEY FOB ARM/DISARM SOUND

❑ OFF (regular setting) ❑ ON

Key Fob Disarm After Alarm Sound

The system can be set so when it’s disarmed with a wireless key fob after an alarm has occurred, a

special series of beeps will sound through the internal and external sounders. This option serves as a

safety alert to warn you to approach the premises with caution as an intruder may still be present.

KEY FOB DISARM AFTER ALARM SOUND

❑ OFF (regular setting) ❑ ON

★ IMPORTANT: If you return to the premises and hear the special beeps when disarming

with the key fob, USE CAUTION! The special beeps indicate that an alarm has occurred

while you were gone. AN INTRUDER MAY STILL BE ON THE PREMISES. LEAVE

IMMEDIATELY AND CONTACT THE POLICE FROM A SAFE LOCATION.

Exit Delay Restart

The Exit Delay Restart option will extend the Exit Delay one time if you need to re-enter the premises.

When the system is armed in the Away Mode or Stay Mode, the Exit Delay gives you time to leave

without setting off the alarm. With the Exit Delay Restart option, re-entering the premises after you

have left, but before the Exit Delay timer expires, will restart the Exit Delay timer, giving you the

full length of time to leave again. The restart option only works once, each time the system is armed.

EXIT DELAY RESTART

❑ ON (regular setting) ❑ OFF

Cancel Time

To limit responses to false alarms, a “cancel” message will be sent to the Central Monitoring Station

if the system is disarmed within a preset period of time after an alarm is triggered. The alarm report

is always sent, but it will be followed by a cancel report if you disarm the system within the preset

time.

This option helps the Central Monitoring Station to determine whether you accidently caused the

alarm or if the alarm report was caused by an intruder. It also lets the Central Station know that you

have returned to the premises. Even if a cancel message is sent, the Central Station will verify the

alarm and possibly dispatch help. The cancel message may be processed by the Central Station at a

later time depending on system programming.

CANCEL TIME

❑ 5 Minutes (regular setting)

_________ Minutes

Installer Set Options