Quick Start Guide
Establishing Communication Between the Bridge and your Mighty Mule Gate Operator
(with radio module installed)
Bridge Module
Control Box with Control Board
Establishing Communication Between the Bridge and Your Mighty Mule Gate Operator
1.
Communication between the Control Board (with radio module) and Bridge Module will automatically attempt to connect.
2.
The LED should be flashing blue as it attempts to connect to the Gate Operator.
3.
Wait approximately 5 minutes to see if your system will connect within the “Low” power level setting.
4.
If the light does not turn green, the power level setting will need to be adjusted.
To Adjust the Power Level Settings:
If the Bridge Module and Radio Module (Control Box) are far enough apart that a connection does not occur after 5 minutes of powering up the unit (the
green LED on the Bridge Module does not turn solid), then the power level will need to be adjusted. The following steps will need to be taken:
1.
Stand next to the gate operator control box.
2.
Open the control box and adjust the power level.
a.
Hold down
S3
for 10 Sec. A visual indication of the current power level setting will be given via
S2
S2
the number of lit LEDs (1 for
Low
, 2 for
Medium
and 3 for
High
).
b.
Adjust the power level up to
Medium
by pressing the
S2
button.
i.
S2 increases the power level setting.
S3
S3
ii.
S4 decreases the power level setting.
3.
Adjust the power level for the Bridge using the Mighty Mule App.
a.
Go to the app
Device Details
page.
S4
S4
b.
Click on the Power Level button (should currently be indicating
Low
).
c.
Select
Medium
(which needs to align with the setting that was set on the control board).
4.
Stand next to your Bridge Module, then wait 5 minutes to ensure that the LED on the Bridge
Module turns solid green.
5.
If the LED on the Bridge Module does not turn green after 5 minutes, repeat steps 1-4 in order
to change the power level to
High
.
NOTE
: The power level will need to be adjusted on both the Control Board and the Bridge Module using the
Mighty Mule App
.
CAUTION:
Do not set the power level setting to “Medium” or “High” if your Bridge Module and the Radio Module are within
25 ft of each other
.
NOTE
: The radio module and the bridge module are paired at the factory. They will attempt to connect after the unit is provisioned.
P
A
I
R
RESET