User's Manual

following keys simultaneously on the Keypad “1-3-7-9” for 2 seconds. The Base will respond with audio
confirmation and the apps will show a success message. If the Keypad fails to register with the Base, the
apps will show a failure message. Possible causes of registration failure include: Keypad not powered,
wrong keys pressed, Keypad out of range with Base, or too many Keypads already registered in
LifeShield System.
Using the Keypad
If the Keypad is AC powered, the display, backlight, and LED will remain on continuously. If you do not
want the backlight on continuously, press the following keys simultaneously on the Keypad “1-3-4” for 2
seconds. This will show a menu option to control backlight ON/OFF.
If the Keypad is battery powered, the Keypad will sleep within 30 seconds after the last key has been
pressed. The next time you press a key, the Keypad must obtain system status from the Security Base.
This status update may take 2 to 5 seconds to receive, and then the display and LED will show current
LifeShield system status.
After you send a command to the Security Base, the Keypad must obtain new system status. This will
again take 2 to 5 seconds, and then the display and LED will update to the new status.
To arm your LifeShield system using the Keypad, press one of Away, Stay, or Instant keys and then enter
your 4 digit code. After you have entered 4 digits, the Keypad will send the arm command to the System
Base. If you have turned on One-Touch Arming in the System Settings (using one of the apps), then a 4
digit code is not required. To use One-Touch Arming, press and hold one of Away, Stay, or Instant keys
and the Keypad will send the arm command. Note that you may only arm your system if current status is
Ready to Arm.
To disarm your LifeShield system, press the Off key then enter your 4 digit code.
If at any time, you enter wrong digits and need to re-start, simply press the desired arming key or Off, and
then your code. If you entered an invalid code, the System Base will update the Keypad display.
To use the panic mode, simultaneously press and hold the * and # buttons.
System Messages
The Keypad can display messages in either English or Spanish. To change language, press the following
keys simultaneously on the Keypad “3-7” for 2 seconds. This will show a menu option to control
language.
The Keypad includes the following messages (to be updated):
ENGLISH SPANISH
LED color (not all
messages have an
LED color)
Decription