Product Notice

2GIG® GC2E Security & Automation System
Regulatory Statements
The GC2E Security & Automation System (2GIG-GC2E) is marked to indicate its
compliance with:
» United States—Federal Communications Commission (FCC)
» Canada—Industry Canada (IC)
Please read the appropriate section that corresponds to the marking on the product
before attempting to install the product.
United StateS, FCC StatementS
Canada, indUStry Canada StatementS
north ameriCan SaFety StandardS
inqUirieS
Wireless Product Notice
Radio controls provide a reliable communication link and ll an important need in
portable wireless signaling; however, there are some limitations which must be
observed.
» For United States installations only: The radios are required to comply with
FCC Rules and Regulations as Part 15 devices. As such, they have limited
transmitter power and therefore limited range (approximately 400 feet
(121.92 meters)).
» A receiver cannot respond to more than one transmitted signal at a time
and may be blocked by radio signals that occur on or near their operating
frequencies, regardless of code settings.
» Changes or modications to the device may void FCC compliance.
Infrequently used radio links should be tested regularly to protect against
undetected interference or fault.
» A general knowledge of radio and its vagaries should be gained prior
to acting as a wholesale distributor or dealer, and these facts should be
communicated to the end users.
FCC Part 15: Class B Digital Device Statement
FCC ID: EF400178
IC: 1078A-00178
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept interference received, including interference that may
cause undesired operation.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one (1) or more of the following
measures:
» Reorient or relocate the receiving antenna.
» Increase the separation between the equipment and receiver.
» Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
» Consult the dealer or an experienced radio/TV technician for help.
NOTE: Any changes or modications made to this device that are not
approved by 2GIG may void the authority granted to the user by the FCC
to operate this equipment.
ICES-003 Class B Notice
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Industry Canada (IC) Compliance Notice
This device complies with Industry Canada license-exempt Radio Standard
Specications (RSS). Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept interference received, including interference that may
cause undesired operation.
Avis de Conformité d’Industrie Canada (IC)
Le présent appareil est conforme aux les Cahiers des charges sur les Normes
Radioélectriques (CNR) d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. l’appareil ne doit pas produire de brouillage, et
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement.
The GC2E Security & Automation System is ETL Listed in North America and when
installed and congured as described in the GC2E Security & Automation System
Installation Guide, meets the standards for:
» UL 985: Household Fire Warning System Units and
» CAN/ULCS545:Residential Fire Warning System Control Units
» UL 1023: Household Burglar Alarm Units and CAN/ULC1023: Household
Burglar Alarm System Units
» UL 1610: Central-Station Burglar-Alarm Units
» ANSI/SIA CP-01-2010: Control Panel Standard - Features for False Alarm
Reduction
Direct all inquiries regarding this regulatory compliance statement to:
Nortek Security &Control LLC
5919 Sea Otter Place, Suite 100
Carlsbad, CA92010
USA
800-421-1587 P/N: 10022257 A
PRINTER’S INSTRUCTIONS
REGULATORY INSERT, GC2E PANEL- P/N: 10022257 A - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 8.5X11”, TOL. +/- 0.125, SCALE: 1:1, FRONT & BACK, FOLD ONCE TO 5.5 x 8.5