Communication Server Large System Installation and Commissioning

Cabling Common Equipment in a Multi Group system Page 213 of 456
Communication Server 1000M and Meridian 1 Large System Installation and Commissioning
Procedure 30
Cabling the Core/Net module backplane
1 Orient the cable connector so the strain relief paddle is to the right.
2 Partially insert the cable connector so its guides mate to the
corresponding backplane connector.
3 Apply a small amount of pressure to push the cable connector straight into
the backplane connector. You will feel a click when the connector seats.
End of Procedure
Disconnecting cables from the Core/Net module backplane
To disconnect cables from the Core/Net module backplane, you must use the
P0741489 Extraction Tool provided, located in the rear of the module (behind
the I/O safety panel).
CAUTION
Damage to Equipment
Use the P0741489 Extraction Tool to disconnect
cables from the backplane shrouds in NT4N41 Core/
Network modules.
Follow the procedure below to avoid bending or
breaking pins when removing cable connectors from
the backplane shrouds.
Do not insert the extraction tool unless the cable
connector is locked into the shroud.
Do not force the extraction tool deeper than the
detent on the cable connector.
Do not improvise with common hand tools.