Communication Server Large System Installation and Commissioning

Adding a module to a column Page 375 of 456

Communication Server 1000M and Meridian 1 Large System Installation and Commissioning

3 Disconnect power connections to the top cap:

a. At the top of the rear of the module, disconnect the orange power

connector from the module power harness (see Figure 130 on

page 375). Press the four tabs (two on each side) and let the

connector fall loose into the module below.

Figure 130

Orange power connector removal tab locations

b. Disconnect the system monitor cable at connector J2 on the

backplane.

4 Remove the top cap and perforated panel:

• For countries other than the UK, pull forward on the clips underneath

the front edge of each air exhaust grill on the top cap. Lift up and

remove the grill as illustrated in Figure 131 on page 375).

Figure 131

Air exhaust grill removal

• In the UK, the front and rear air exhaust grills are secured by Southco

fasteners located underneath the front edge of the grill. Use a #1

553-5888

Orange connector

Push here

Air exhaust grill

Top cap

Module

Clips

553-5886