User Manual
Table Of Contents
- Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
- Release 3.0.0.0
- Preface
- Chapter 1 Overview
- Chapter 2 Quick start software installation
- Chapter 3 Driver and utility software installation and uninstallation
- Chapter 4 Configuring basic network settings
- Chapter 5 Configuring network security
- Chapter 6 Upgrading the driver and utility software
- Appendix A Troubleshooting guidelines
- Appendix B Specifications
- Frequency band
- Modulation technique
- Host interface
- Operating channels supported
- Operating voltage
- Power consumption
- Current consumption
- Output power
- Operating systems support ed
- Dimensions
- Security
- Operation mode
- Transfer data rate
- Operating temperature
- Storage temperature
- Humidity
- Compliance standards
- Media access protocol
- Mechanical specification
24 Chapter 2 Quick start software installation
216669-A
Preliminary Draft - Nortel Networks Confidential
5 Click on Next. (Or, alternatively, use the Browse button to select a different
destination folder and then click on Next.) A message prompting you to insert
the Nortel Networks WLAN - Mobile Adapter 2202 card appears.
6 Insert the Nortel Networks WLAN - Mobile Adapter 2202 card into the
CardBus slot and click on OK. The Setup Status window opens.
As the installation progresses, the Setup Status progress bar lets you monitor
the installation process.
7 If the Digital Signature Not Found dialog box or the Windows XP
compatibility testing dialog box appears during driver installation, click on
Yes (Windows 2000) or on Continue Anyway (Windows XP) to continue the
installation. Otherwise, go directly to step 8.
8 When the installation completes the Click OK to reboot the system message
appears. Click on OK to reboot the system and complete the installation.
Note: If the Found New Hardware Wizard appears, click on Cancel to
continue with the installation.