User Manual
Table Of Contents
- Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
- Release 3.0.0.0
- Preface
- Chapter 1 Overview
- Chapter 2 Quick start software installation
- Chapter 3 Driver and utility software installation and uninstallation
- Chapter 4 Configuring basic network settings
- Chapter 5 Configuring network security
- Chapter 6 Upgrading the driver and utility software
- Appendix A Troubleshooting guidelines
- Appendix B Specifications
- Frequency band
- Modulation technique
- Host interface
- Operating channels supported
- Operating voltage
- Power consumption
- Current consumption
- Output power
- Operating systems support ed
- Dimensions
- Security
- Operation mode
- Transfer data rate
- Operating temperature
- Storage temperature
- Humidity
- Compliance standards
- Media access protocol
- Mechanical specification
Chapter 3 Driver and utility software installation and uninstallation 29
Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
Preliminary Draft - Nortel Networks Confidential
Figure 9 Digital Signature Not Found dialog box
8 When the installation completes, the utility prompts you to reboot (Figure 10).
Click on OK or Cancel as desired.
Figure 10 Reboot prompt
When the system completes rebooting, the Mobile Adapter 2202 Utility icon
appears in the system tray (Figure 11). The Mobile Adapter 2202 Utility icon
is the icon to the left of the system time in Figure 11.
Figure 11 WLAN Mobile Adapter Utility Icon in system tray
Periodically, you should check the Nortel Networks support Web site for upgraded
versions of the Mobile Adapter 2202 software. If you find a newer version of the
2202 driver and utility software, use the procedure in “Upgrading the driver and
utility software” on page 63 to install it.