User Manual
Table Of Contents
- Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
- Release 3.0.0.0
- Preface
- Chapter 1 Overview
- Chapter 2 Quick start software installation
- Chapter 3 Driver and utility software installation and uninstallation
- Chapter 4 Configuring basic network settings
- Chapter 5 Configuring network security
- Chapter 6 Upgrading the driver and utility software
- Appendix A Troubleshooting guidelines
- Appendix B Specifications
- Frequency band
- Modulation technique
- Host interface
- Operating channels supported
- Operating voltage
- Power consumption
- Current consumption
- Output power
- Operating systems support ed
- Dimensions
- Security
- Operation mode
- Transfer data rate
- Operating temperature
- Storage temperature
- Humidity
- Compliance standards
- Media access protocol
- Mechanical specification
32 Chapter 3 Driver and utility software installation and uninstallation
216669-A
Preliminary Draft - Nortel Networks Confidential
5 Click on OK. The Stopping the Configuration Service. This may take up
to thirty seconds... message appears followed by the Do you really wish to
remove the device driver? This removes your profiles. dialog box
(Figure 16).
Figure 16 Remove the device driver dialog box
6 Click on Yes unless you plan to reinstall the Mobile Adapter 2202 software or
install a newer version of the Mobile Adapter 2202 software in the near future.
If you intend to reinstall the Mobile Adapter 2202 software or install a newer
version of it in the near future, click on No to save your profiles.
The progress bar in the Setup Status window shows the progress of the
uninstallation operation (Figure 17). When the uninstallation operation
completes, the utility prompts you to reboot (Figure 18).
Figure 17 Setup Status window