User Manual
Table Of Contents
- Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
- Release 3.0.0.0
- Preface
- Chapter 1 Overview
- Chapter 2 Quick start software installation
- Chapter 3 Driver and utility software installation and uninstallation
- Chapter 4 Configuring basic network settings
- Chapter 5 Configuring network security
- Chapter 6 Upgrading the driver and utility software
- Appendix A Troubleshooting guidelines
- Appendix B Specifications
- Frequency band
- Modulation technique
- Host interface
- Operating channels supported
- Operating voltage
- Power consumption
- Current consumption
- Output power
- Operating systems support ed
- Dimensions
- Security
- Operation mode
- Transfer data rate
- Operating temperature
- Storage temperature
- Humidity
- Compliance standards
- Media access protocol
- Mechanical specification
36 Chapter 4 Configuring basic network settings
216669-A
Preliminary Draft - Nortel Networks Confidential
Figure 20 Profile Management window — General tab
3 Enter a Profile Name and the correct SSIDs for the network that you are going
to join. (The Client Name is supplied by the utility.) Table 2 describes the
items on the Profile Management Settings - General tab.
4 Click on the Security tab (Figure 21) to display the Set Security Options. By
default, the security option for the network profile is set to None. To complete
the basic configuration procedure, leave the security option set to None for
now.
Table 2 Profile Management Settings — General tab
Item Description
Profile Name This name identifies the configuration. This name must be
unique.
Client Name The client name is the name of the computer in which the
Mobile Adapter 2202 card is installed.
SSID (1-3) The name of the wireless network. This name cannot be
longer than 32 characters. If the field is set to be “ANY” or
is left blank, your computer will connect to an AP with the
best signal strength.