User Manual
Table Of Contents
- Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
- Release 3.0.0.0
- Preface
- Chapter 1 Overview
- Chapter 2 Quick start software installation
- Chapter 3 Driver and utility software installation and uninstallation
- Chapter 4 Configuring basic network settings
- Chapter 5 Configuring network security
- Chapter 6 Upgrading the driver and utility software
- Appendix A Troubleshooting guidelines
- Appendix B Specifications
- Frequency band
- Modulation technique
- Host interface
- Operating channels supported
- Operating voltage
- Power consumption
- Current consumption
- Output power
- Operating systems support ed
- Dimensions
- Security
- Operation mode
- Transfer data rate
- Operating temperature
- Storage temperature
- Humidity
- Compliance standards
- Media access protocol
- Mechanical specification
Chapter 4 Configuring basic network settings 43
Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
Preliminary Draft - Nortel Networks Confidential
This feature is useful when you need to connect to the network from different
locations and you have created a profile with different settings for each location.
This feature applies only to profiles that have infrastructure specified as the
network type, and to profiles that specify only one SSID. In addition, if more than
one profile uses the same SSID, only one of those profiles can be added to the
Auto Selected Profiles list.
To add, remove, and order profiles for auto selection:
1 Click on the Order Profiles button on the Program Management tab
(Figure 30) to display the Auto Profile Selection Management window
(Figure 31). All the profiles that you created are displayed in the Available
Profiles area.
Figure 30 Profile Management tab — ordering profiles
Note: The “Default” profile cannot be added to the Auto Selected
Profiles list.