User Manual
Table Of Contents
- Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
- Release 3.0.0.0
- Preface
- Chapter 1 Overview
- Chapter 2 Quick start software installation
- Chapter 3 Driver and utility software installation and uninstallation
- Chapter 4 Configuring basic network settings
- Chapter 5 Configuring network security
- Chapter 6 Upgrading the driver and utility software
- Appendix A Troubleshooting guidelines
- Appendix B Specifications
- Frequency band
- Modulation technique
- Host interface
- Operating channels supported
- Operating voltage
- Power consumption
- Current consumption
- Output power
- Operating systems support ed
- Dimensions
- Security
- Operation mode
- Transfer data rate
- Operating temperature
- Storage temperature
- Humidity
- Compliance standards
- Media access protocol
- Mechanical specification
Chapter 5 Configuring network security 61
Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
Preliminary Draft - Nortel Networks Confidential
5 Define the pre-shared keys and select one of the four WEP keys to be used as
the default key for transmitting packets. (Typically, WEP Key 1 is used as the
default.)
6 Click on OK.
7 If the access point that the wireless adapter is associating to has WEP set to
Optional and the client has WEP enabled, make sure that Allow Association
to Mixed Cells is selected on the Security tab to allow association.
8 Click on OK to save the security settings for the profile and return to the
Profile Management window.
9 To enable the profile, highlight the profile and click on the Activate button.