User Manual
Table Of Contents
- Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
- Release 3.0.0.0
- Preface
- Chapter 1 Overview
- Chapter 2 Quick start software installation
- Chapter 3 Driver and utility software installation and uninstallation
- Chapter 4 Configuring basic network settings
- Chapter 5 Configuring network security
- Chapter 6 Upgrading the driver and utility software
- Appendix A Troubleshooting guidelines
- Appendix B Specifications
- Frequency band
- Modulation technique
- Host interface
- Operating channels supported
- Operating voltage
- Power consumption
- Current consumption
- Output power
- Operating systems support ed
- Dimensions
- Security
- Operation mode
- Transfer data rate
- Operating temperature
- Storage temperature
- Humidity
- Compliance standards
- Media access protocol
- Mechanical specification
Chapter 6 Upgrading the driver and utility software 65
Installing and Using the Nortel Networks Wireless LAN Mobile Adapter 2202
Preliminary Draft - Nortel Networks Confidential
Figure 47 Previous Installation Detected window
3 Select Update the previous installation if it is not already selected and click
on Next. The message dialog box shown in Figure 48 appears.
Figure 48 Option requires system reboot dialog box
4 Click on Ye s . The Stopping the Configuration Service message appears
(Figure 49).
Figure 49 Stopping the Configuration Service message
After the configuration service stops, the message disappears and the Setup
Status window is visible again (Figure 50).