User's Manual

March 16, 2004 21
Step 4: Mounting the Nortel Networks WLAN - Access Points
Note: If the screws do not securely hold the bracket, remove the Nortel Networks WLAN -
Access Point and adjust the screws until they securely hold the bracket.
Figure - Assembling the Nortel Networks WLAN - Access Point to the Projection-Mount Bracket
• Attach the cables to the sides of the Nortel Networks WLAN - Access Point.
Note: Make sure the cables are routed away from the Nortel Networks WLAN - Access Point
antennas.
Note: When the Nortel Networks WLAN - Access Point is powered up and is associated with an
Nortel Networks WLAN - Wireless Security Switch (Green/Power and Yellow/802.11b/g and/or
Yellow or Amber/802.11a LEDs lit), the Nortel Networks WLAN - Access Point begins broad-
casting its beacon signal(s). When this happens, complete the installation as quickly as
possible to remove yourself from within 8 inches (20 cm) of the Nortel Networks WLAN -
Access Point to comply with FCC RF radiation exposure guidelines.
You have installed the Nortel Networks WLAN - Access Point. Repeat Step 4: Mounting the Nortel
Networks WLAN - Access Points for each Nortel Networks WLAN - Access Point location, and then
continue with Step 5: Returning MAC Information
.
Flush Wall MountFlush Wall Mount
When you are mounting the Nortel Networks WLAN - Access Point against a wall (flat side toward the
inside of the building), use an optional separately-orderable factory-orderable flush-mount bracket.
• Before proceeding, gently screw the two factory-supplied screws and spring washers into the
bottom of the Nortel Networks WLAN - Access Point. Make sure the spring washers have their
convex (high center sections) pointing toward the screw heads.