User's Manual
Table Of Contents
- External-Antenna Nortel Networks WLAN - Access Point Quick Installation Guide
- ATTENTION!
- Overview
- Step 1: Collecting Required Tools and Supplies
- Step 2: Configuring the Nortel Networks WLAN - Access Point or Remote Edge Access Point Before Installation
- Step 3: Preparing Mounting Locations
- Step 4: Mounting the Nortel Networks WLAN - Access Points
- Step 5: Returning MAC Information
- Planning Notes
- Safety Considerations
March 16, 2004 22
Step 4: Mounting the Nortel Networks WLAN - Access Points
Note: The Nortel Networks WLAN - Access Point threaded holes have precision-depth threads.
Do not overtighten the screws, or the bracket will not fit under the screw heads.
Figure - Assembling the Mounting Screws and Spring Washers to the Nortel Networks WLAN - Access Point
• Copy the MAC address(es) from the label(s) on the Nortel Networks WLAN - Access Point onto
the corresponding location on the map. MAC addresses have the format 000B85xxxxxx.
• You have already attached the flush-mount bracket to the wall in Step 3: Preparing Mounting
Locations.
• Slide the screws into the keyhole slots on the mounting bracket as shown in the following
figure.
Note: Make sure the side of the Nortel Networks WLAN - Access Point with the door is facing
away from the wall. This ensures that the correct antenna is facing the building, and makes
future upgrades easier.