- Nortel Ethernet Routing Switch Owner's Manual

160 Power over Ethernet for the Ethernet Routing Switch 2526T-PWR and 2550T-PWR
Table 35 "poe poe-power-usage-threshold command parameters and
variables" (page 160) describes the parameters and variables for the poe
poe-power-usage-threshold command.
Table 35
poe poe-power-usage-threshold command parameters and variables
Parameters and
variables
Description
<1-99>
Enter the percentage of total available power you
want the switch to use prior to sending a trap.
ATTENTION
The default setting is 80%.
Unit
Set a percentage usage threshold above which the
system sends a trap for each unit.
poe poe-trap command
The poe poe-trap command enables the traps for the PoE functions on
the Ethernet Routing Switch 2500-PWR. The syntax for the poe poe-trap
command is:
poe poe-trap {Unit}
The poe poe-trap command is executed in the Global Configuration
command mode.
no poe-trap command
The no poe-trap command disables the traps for the PoE functions on
the Ethernet Routing Switch 2500-PWR. The syntax for the no poe-trap
command is:
no poe-trap {Unit}
The no poe-trap command is executed in the Global Configuration
command mode.
Configuring PoE port parameters using the CLI
You can configure power parameters for each port on the Ethernet Routing
Switch 2500 PWR Series using the CLI. You enable the power and set
the power limit and power priority on each port. This section covers the
following topics:
•
"no poe-shutdown command" (page 161)
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.