- Nortel Ethernet Routing Switch Owner's Manual

222 System configuration using the CLI
Parameters and
variables
Description
port-desc Port description TLV.
sys-cap
System capabilities TLV
sys-desc System description TLV
sys-name
System name TLV
default lldp tx-tlv command
The default lldp tx-tlv command specifies the optional TLVs not
to include in the transmitted LLDPDUs (by default, the optional TLVs are
not included in LLDPDUs). The syntax for the default lldp tx-tlv
command is:
default lldp tx-tlv [port <portlist>] [local-mgmt-addr]
[port-desc]
[sys-cap] [sys-desc] [sys-name]
The default lldp tx-tlv command is executed in the Interface
Configuration command mode.
Table 83 "default lldp tx-tlv command parameters and variables" (page
222) describes the parameters and variables for the default lldp tx-tlv
command.
Table 83
default lldp tx-tlv command parameters and variables
Parameters and
variables
Description
port <portlist>
Specifies the ports affected by the command.
local-mgmt-addr Local management address TLV (default value is false: not
included)
port-desc Port description TLV. (default value is false: not included)
sys-cap
System capabilities TLV (default value is false: not included)
sys-desc System description TLV (default value is false: not included)
sys-name
System name TLV (default value is false: not included)
lldp status command
The lldp status command sets the LLDPU transmit and receive status
on ports. The syntax for the lldp status command is:
lldp [port <portlist>] status [rxOnly | txAndRx | txOnly]
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.