- Nortel Ethernet Routing Switch Owner's Manual

Enabling rate-limiting 243
This section contains information about the following:
•
"show rate-limit command" (page 243)
•
"rate-limit command" (page 243)
•
"no rate-limit command" (page 244)
•
"default rate-limit command" (page 244)
show rate-limit command
The show rate-limit command displays the rate-limiting settings and
statistics. The syntax for the show rate-limit command is:
show rate-limit
The show rate-limit command is executed in the Privileged EXEC
command mode.
The show rate-limit command has no parameters or variables.
Figure 88 "show rate-limit command output" (page 243) displays sample
output from the show rate-limit command.
Figure 88
show rate-limit command output
rate-limit command
The rate-limit command configures rate-limiting on the switch.
The syntax for the rate-limit command is:
rate-limit [multicast | broadcast | both] <0-262143>
The rate-limit command is executed in the Global Configuration
command mode.
Table 103 "rate-limit command parameters and variables" (page
244) describes the parameters and variables for the rate-limit command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.