User Guide

58 Chapter 5 DIP switch settings
209375-A
Table 10 shows the switch settings for resetting your unit to factory default
conditions.
Resetting your Instant Internet unit
Before you reset your Instant Internet unit, be sure to back up the configuration.
If you back up the configuration, you can easily restore it. For details, refer to
Using the BayStack Instant Internet Management Software Version 7.11.
To reset your Instant Internet unit:
1 Turn off your unit.
2 Set the switches to the configuration you want.
Refer to Switch settings for special configurations on page 56.
Table 10 Switch settings for resetting factory default conditions
12345678
OFF
••
ON
••• ••
Caution: If you use these switch settings to reset your unit to factory
default conditions, the following user-defined settings are removed or
reset: password, hosts, port mappings, unit configuration, access
restrictions, unit registration, and encryption authorization.
If you purchased and installed the 3DES Encryption Module (part number
CQ1010005), you need to reinstall it.
If you used the switch settings in Table 9 to disable the reset password and
configuration switch settings, these settings are re-enabled.