User Guide

Installing and Connecting the TokenSpeed Module
893-01019-A 3-5
5.
To seat the module against the backplane, rotate the inserter/extractor
levers inward toward each other (see Figur
e 3-5).
Figure 3-5. Seating the module
When the front panel of the module is flush with the front of the chassis, the
module backplane connectors are properly seated.
6. Align and tighten the captive retaining screw at each end of the module
front panel (see Figur
e 3-5).
Connecting Cables to TokenSpeed Ports
This section describes how to connect cables to the ports on a TokenSpeed
module with the following connections:
• Token ring connections to the RJ-45 ports
• Management connection to the MCP port
6537
TKNSPD.BK Page 5 Thursday, July 17, 1997 11:43 AM