User Guide

Using the 8-port TokenSpeed and TokenSpeed/MCP Switch Modules
3-10 893-01019-A
If the factory default settings are not appropriate for your network, you may be
able to use one of the predefined switch configurations that are available in
SpeedView. You simply choose one of these without having to configure
individual ports.
Filters Disabled Disabled, Enabled
Note: Do not enable both NetBIOS filtering and packet filtering on the same port. When both types of
filtering are enabled, only the NetBIOS filtering is active.
Bridge group 1 1–32
Virtual ring number
(Valid only when source route
bridging is selected.)
For ports 1 through 8 on each slot in
hexadecimal format:
Slot 1: 11, 12, 13, 14, 15, 16, 17, 18
Slot 2: 21, 22, 23, 24, 25, 26, 27, 28
Slot 3: 31, 32, 33, 34, 35, 36, 37, 38
Slot 4: 41, 42, 43, 44, 45, 46, 47, 48
Slot 5: 51, 52, 53, 54, 55, 56, 57, 58
Slot 6: 61, 62, 63, 64, 65, 66, 67, 68
1–FFE
Note: The Centillion 50 switch contains only slots 1 through 3.
Priority
(Valid only when source route
bridging is selected.)
128 0–255
Path cost
(Valid only when source route
bridging is selected.)
16 1–65535
ARE hop count
(Valid only when source
route bridging is selected.)
7 1–7 or 1–13
STE hop count
(Valid only when source route
bridging is selected.)
7 1–7 or 1–13
SR broadcasting
(Valid only when source route
bridging is selected.)
Auto Auto, Off, On
Table 3-3. Factory default configuration settings (continued)
Parameter Factory default Possible settings
TKNSPD.BK Page 10 Thursday, July 17, 1997 11:43 AM