Manual

Nortel Secure Router 8000 Series
Configuration -WAN Access 9 HDLC configuration
Step 2 Configure Router B.
<Nortel> system-view
[Nortel] sysname RouterB
[RouterB] interface pos 1/0/0
[RouterB-Pos1/0/0]
[RouterB-Pos1/0/0]
[RouterB-Posl/0/0]
[RouterB-Pos1/0/0]
[RouterB-Posl/0/0]
link-protocol hdlc
ip address 100.1.1.2 24
shutdown
undo shutdown
quit
Step 3 Configure the static routing on Router A.
[RouterA] ip route-static 100.1.1.0 24 pos 1/0/0
Step 4 Verify the configuration.
Router A and Router B can ping through each other.
For example.
[RouterA] ping 100.1.1.2
PING 100.1.1.2: 56 data bytes, press CTRL_C to break
Reply from 100.1 1.2: bytes=56 Sequence=1 ttl=255 time=31 ms
Reply from 100.1 1.2: bytes=56 Sequence=2 ttl=255 time=63 ms
Reply from 100.1 1.2: bytes=56 Sequence=3 ttl=255 time=63 ms
Reply from 100.1 1.2: bytes=56 Sequence=4 ttl=255 time=63 ms
Reply from 100.1 1.2: bytes=56 Sequence=5 ttl=255 time=63 ms
-- 100 .1.1.2 ping statistics -- -
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 31/56/63 ms
Run the display ip routing-table command to check the correctness of the routing table.
[RouterA] display ip routing-table
Routing Tables: Public
Destinations : 4 Routes 4
nation/Mask Proto Pre Cost NextHop Interface
100.1.1.0/24 Static 60 0 100.1.1.1 POS1/0/0
100.1.1.1/32 Direct 0 0 127.0.0.1 InLoopBack0
127.0.0.0/8 Direct 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 Direct 0 0 127.0.0.1 InLoopBack0
—End
Configuration files
• Configuration file of Router A
#
sysname RouterA
#
interface Pos1/0/0
link-protocol hdlc
ip address unnumibered interface LoopBack!
#
interface LoopBack1
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
9-9