Server User Manual

212 Install and configure IP Trunk 3.01 (and later) node
•
8 data bits
•
1 stop bit, no parity
•
no flow control
NTMF29BA DCHIP cable
The NTMF29BA DCHIP cable connects to port 0 of the DCHIP PC Card
and the MSDL/SDI DCHIP cable.
Port 1 on the DCHIP PC Card is not used.
The DCHIP PC Card, which connects to NTMF04BA and NTND26AA
Cable, is keyed to allow insertion only in the correct direction. Refer to
Figure 45 "NTMF29BA PC Card DCHIP cable installation" (page 212).
Figure 45
NTMF29BA PC Card DCHIP cable installation
To assemble the DCHIP cable, follow the steps in Procedure 15 "Assembling
the DCHIP cable" (page 212).
Procedure 15
Assembling the DCHIP cable
Step Action
1
Insert the DCHIP bracket through the small slot to the left of the PC
Card opening in the faceplate, as shown in Figure 45 "NTMF29BA
PC Card DCHIP cable installation" (page 212).
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright © 2007, Nortel Networks
.