Server User Manual

234 Install and configure IP Trunk 3.01 (and later) node
LD 86 Configure Route List Block with Step Back on Congestion on ISDN
Prompt Response Description
REQ NEW Add new data.
CUST
xx
Customer number as defined in LD 15.
FEAT RLB Route List Data Block.
RLI
xxx
Route List Index to be accessed, where xxx is:
0-127 for BARS
0-255 for NARS
0-999 for FNP
ENTR
xx
Entry number for NARS/BARS Route List, where xx is:
0-63 for BARS/NARS
...
ROUT Route number
0-511
Range for Large System, Call Server 1000E, and Media
Gateway 1000E
0-127
Range for Small System and Media Gateway 1000B.
TOD Time of Day Schedule
If required, turn off IP Trunk 3.01 (and later) trunk route
during peak traffic periods on the IP data network.
FRL Facility Restriction Level
Set FRL appropriately to control access to the IP Trunk
3.01 (and later) route.
DMI
0
Do not use a Digit Manipulation table in the RLB entry for
the IP Trunk 3.01 (and later) route.
For ESN translations that are not used for
non-call-associated signalling, digit manipulation
can be defined on the IP Trunk 3.01 (and later) node dialing
plan in the Digits dialed tab.
SBOC Step Back on Congestion.
RRA Re-route all. Enter RRA at the SBOC prompt to enable
Fallback to alternate circuit-switched trunk route
IP Trunk 3.01 (and later) must have SBOC=RRA for QoS fallback to work.
LD 87 Configure the Co-ordinated Dialing Plan (CDP)
Prompt Response Description
REQ NEW Add new data.
CUST
xx
Customer number as defined in LD 15.
FEAT CDP Coordinated Dialing Plan.
Nortel Communication Server 1000
IP Trunk Fundamentals
NN43001-563 02.01 Standard
Release 5.5 21 December 2007
Copyright © 2007, Nortel Networks
.