Server User Manual

ManualsBrandsNortel Networks ManualsServerNN43001-563

371

372

373

374

375

376

377

378

379

380

Access the ITG shell through a maintenance port or Telnet 377

The time to re-register is based on the clock on the Leader 0 IP trunk

card. If the clocks on the Leader 1 and Follower IP trunk cards are out of

synchronization with the Leader 0 clock, the time to re-register might be

incorrect. The time that the next re-register will occur is always correct on

the Leader 0 IP trunk card.

The following is an example of the output of the gkshow command when

there is only a Primary Gatekeeper.

---------------------------------------

<<PROVISIONED>>

The H.323 ID of this gateway is : [Shane_IPT_cust0]

First place dialed numbers are resolved: ATPM

Second place numbers are resolved : Gatekeeper

Cards that register with the Gatekeeper: All

<<OPERATIONAL>>

The Current Gatekeeper is : Primary

The Current Gatekeeper status is : Registered

<<From the Gatekeeper>>

The Time To Live (TTL) for the node is : 300 seconds

The remaining time to Re-Register is : 276 seconds

The Gateway End Point ID is :

.0.2.6.1.3.1.e.8.2.0.0.3.0.2.0.6.1.4.0.4.0.7.0.0.0.2.b.3.8

.6.2.6.a.7

The Gatekeeper has Pre-Granted ARQ : Not Granted - direct

calls possible

---------------------------------------

Primary Gatekeeper information <<PROVISIONED>>

----------------------------------------

Primary Gatekeeper type is : CSE1000

Primary Gatekeeper IP information is :

*Gatekeeper IP : 47.11.249.140

*QoS Enabled : 0

*Node Capability : 9 - CSE - Interop Format

---------------------------------------

value = 2 = 0x2

Transfer ﬁles through the Command Line Interface

Type one of the following commands at the ITG shell Command Line

Interface (CLI) to enable these actions:

•

transfer a ﬁle from the IP trunk card to an FTP host

•

transfer a ﬁle from an FTP host to the IP trunk card

The correct command depends on the type of ﬁle to be transferred.

These commands are from the point of view of the IP trunk card. Commands

with "Get" as part of the command name refer to ﬁle transfer from the FTP

host to the IP trunk card. Commands with "Put" as part of the command

name refer to ﬁle transfer from the IP trunk card to the FTP host.

Nortel Communication Server 1000

IP Trunk Fundamentals

NN43001-563 02.01 Standard

Release 5.5 21 December 2007