Server Hardware Installation Instructions

30 Chapter 3 Preparing for installation

IF THEN

components have become loose secure them.

Refer to the procedures in the

Installation and Configuration

Task List (NN44200-306).

you are satisfied that the 1002rp

server has arrived at your site

undamaged

replace the server cover and

proceed with the hardware

installation.

See "Installation checklist" (page

23).

Note: Do not reinstall the front

bezel until the server is in its

final location and the CallPilot

installation is complete.

—End—

To replace the front bezel after installation is complete

Step Action

When the CallPilot server installation is complete and the server is in its

ﬁnal location, replace the front bezel.

Align the front bezel with the ball studs located at each faceplate

corner.

See the diagram below:

Nortel CallPilot

1002rp Server Hardware Installation

NN44200-300 01.01 Standard

5.0 23 February 2007