Manualshelf

Switch User Manual

ManualsBrandsNortel Networks ManualsSwitchNN47200-503
101102103104105106107108109110
IP routing configuration using the CLI 105
ping-virtual-address enable
The ping-virtual-address enable command is executed in the
Router Configuration mode.
no ping-virtual-address enable command
The no ping-virtual-address enable command is used to disable
ICMP echo replies from VRRP associated addresses.
The syntax of the no ping-virtual-address enable command is:
no ping-virtual-address enable
The no ping-virtual-address enable command is executed in the
Router Configuration mode.
send-trap enable command
The send-trap enable command is used to enable the sending of
SNMP notifications after virtual router state changes.
The syntax of the send-trap enable command is:
send-trap enable
The send-trap enable command is executed in the Router Configuration
mode.
no send-trap enable command
The no send-trap enable command is used to disable the sending of
SNMP notifications after virtual router state changes.
The syntax of the no send-trap enable command is:
no send-trap enable
The no send-trap enable command is executed in the Router
Configuration mode.
ip vrrp address command
The ip vrrp address command is used to associated an IP address
with a virtual router ID.
The syntax of the ip vrrp address command is:
ip vrrp address <vr_id> <ip_address>
The <vr_id> parameter represents the virtual router being configured.
This is a value between 1 and 255. The <ip_address> parameter
represents the address to be used in the association.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.