Switch User Manual

110 IP Routing Configuration and Management
ip vrrp priority command
The ip vrrp priority command is used to assign a priority to a virtual
router.
The syntax of the ip vrrp priority command is:
ip vrrp <vr_id> priority <priority_value>
The <vr_id> parameter represents the virtual router being configured.
The <priority_value> parameter represents the priority assigned to the
virtual router. This is a value between 1 and 255.
The ip vrrp priority command is executed in the Interface
Configuration mode.
show ip vrrp command
The show ip vrrp command is used to display VRRP configuration
information and statistics.
The syntax of the show ip vrrp command is:
show ip vrrp [address] [interface]
Use either the address key word to display address-related VRRP
information or interface to display interface-related VRRP information.
Using neither displays basic global configuration information.
The command is executed in the Global Configuration mode.
Equal Cost MultiPath (ECMP) commands
The Equal Cost MultiPath (ECMP) feature allows routers to determine equal
cost paths to the same destination prefix. The multiple paths can be used
for load sharing of traffic and allows faster convergence to other active paths
in case of network failure. This section describes the CLI commands used
to configure ECMP on the switch.
Note: ECMP is only supported on the Nortel Ethernet Routing Switch
5520 and 5530. ECMP will work in a mixed stack but will not run on any
Nortel Ethernet Routing Switch 5510 units in the stack.
rip maximum-path command
The rip maximum-path command is used to configure the number of
ECMP paths allotted for the Routing Information Protocol (RIP).
The syntax of the rip maximum-path command is:
rip maximum-path <path_count>
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.