Switch User Manual

114 IP Routing Configuration and Management
clear ip forward-protocol udp counters command
The clear ip forward-protocol udp counters command clears
the UDP broadcast counters on each interface.
TIP: Stacking - the clear ip forward-protocol udp counters
command is executed only on the base unit in a stack.
The syntax for the clear ip forward-protocol udp counters
command is:
clear ip forward-protocol udp counters <1-4094>
where the parameter <1-4094> specifies the VLAN ID.
The clear ip forward-protocol udp counters command is
executed in the Configuration mode.
ip forward-iprotocol udp command (interface mode)
The ip forward-protocol udp command command, in interface
mode, is used to attach and configure UDP broadcast forwarding lists on
VLAN interfaces (only one list can be attached to a VLAN interface at a time).
The syntax of the ip forward-protocol udp command (interface
mode) command is:
ip forward-protocol udp [vlan <vlan_id> portfwdlist
<forward_list> broadcastmask <bcast_mask> maxttl <max_ttl>]
The following table outlines the parameters of this command:
ip forward-protocol udp (interface mode) parameters
Parameter Description
<vlan_id> The VLAN ID of the interface on which the UDP
forwarding list will be attached.
<forward_list> The ID of the UDP forwarding list which will be attached
to the selected VLAN interface.
<bcast_mask> The 32 bit mask which will be used by the selected
VLAN interface to take forwarding decisions based on the
destination IP address of the incoming UDP broadcast
traffic.
<max_ttl> The TTL value which will be inserted in the IP headers of
the forwarded UDP packets coming out of the selected
VLAN interface.
The ip forward-protocol udp command (interface mode)
command is executed in the Interface Configuration mode.
Nortel Ethernet Routing Switch 5500 Series
Configuration-IP Routing Protocols
NN47200-503 03.01 Standard
5.1 27 August 2007
Copyright © 2005-2007, Nortel Networks
.